CME BodyGuard 545 Color Vision Directions For Use Manual page 34

16. Enter VTBI in ml. To change any numeric
program parameter just enter the numbers
which will replace the previous values and this
will overwrite the previous value. If you make
a mistake press
digit. Press
17. Scroll and select between mL only and
concentration units. Press
18. Set concentration value. Press
NOTE: The rate now will be set in the relevant units.

19. Change the initial rate using the numeric
keypad. If the rate step does not appear then
the maximal rate under "Change Set Up" has
been set to 0ml/hr to prevent users from
delivering regimes with a continuous element.
If you have the authority to change this go to
"Change Set Up" (see later section). If the
desired rate for the protocol you are editing is
in ml/hr then enter the rate and press
accept. Press
NOTE: The BodyGuard 545 Color Vision

rates of up to 30ml/hr. User can enter a maximum basal rate in "Change Set
Up" using the level three access-code to ensure other users can not
accidentally program the pump to deliver above the safe ceiling for your
commonly used drugs.
BodyGuard 545 Color Vision™ Directions For Use
which will delete the last
when correct value is entered.
to confirm.
to confirm.
EPIDURAL
A: Levobupivacaine
Volume To Be Infused
100
Enter and Press
EPIDURAL
A: Levobupivacaine
Concentration
mL Only
mcg
mg
Select
to confirm.
EPIDURAL
A: Levobupivacaine
Concentration
10
Enter and Press
EPIDURAL
A: Levobupivacaine
Initial Rate
2
mcg/hr
Enter and Press
to
is capable of continuous (basal)
TM
4 - Operation
10:00 - 70%
mL
Key
10:00 - 70%
, and press
10:00 - 70%
mcg/mL
Key
10:00 - 70%
Key
█
■
█
■
:
█
■
█
■
34