Error Messages - Sega -RaceTV Owner's Manual

17-2 ERROR MESSAGES

This product displays the following messages when it detects an error. Read the error description and follow
the steps indicated. Refer to the LINDBERGH Service Manual for details on error messages displayed with the
LINDBERGH logo.
Error 11
JVS I/O board is not connected to main board.
The I/O board and the LINDBERGH have been disconnected.
Check to make sure the I/O board and the LINDBERGH are properly connected.
Error 12
JVS I/O board does not fulfill the game spec.
The number of I/O boards are not sufficient to run the application.
Check to make sure the I/O board and the LINDBERGH are properly connected.
Error 15
Game Program Not Found.
The key chip intended for the application is not connected or is loose.
Check to make sure the key chip and the LINDBERGH are properly connected.
Error 1000
Network is Disconnected.
Communication has been broken.
This occurs when the packet does not arrive in a specific amount of time.
Check to make sure the network devices of all the cabinets are properly connected.
See the NOTE below.
Error 1001
MAIN-Cabinet Not Found.
The main cabinet (CABINET ID 1) was not found when the application was started or a timeout occurred
while waiting for communication. Communication will time out after approximately 2 minutes.
- In GAME TEST mode, check to make sure the main cabinet (CABINET ID 1) is properly set up.
- In the case of a time out, turn the power to all the connected cabinets off and then on again.
Error 1002
SUB-Cabinet Not Found.
The sub cabinets (CABINET ID 2-4) were not found when the application was started or a timeout occurred
while waiting for communication. Communication will time out after approximately 2 minutes.
- In GAME TEST mode, check to make sure the sub cabinets (CABINET ID 2-4) are properly set up.
- In the case of a time out, turn the power to all the connected cabinets off and then on again.
17
95