Force Feedback - Sega -RaceTV Owner's Manual

9-3-4 FORCE FEEDBACK

When you select "FORCE FEEDBACK" , a connection test runs and the STEERING rotates.
Make sure that no one is touching the STEERING before running these tests as contact
may cause injury.
9
After the check is completed, the following FORCE FEEDBACK screen will appear, and you will be able to set the
level of STEERING resistance.
● FORCE:
● FORCE TEST:
Move the cursor to EXIT and press the TEST Button to return to the Game Test Menu Screen.
50
FORCE FEEDBAC�
(MIN 0 : MAX �0 : DEFA�LT 4)
->
SELECT WITH SERVICE B�TTON
AND PRESS TEST B�TTON
9-3-4 FIG. 01
Set the STEERING resistance. The ** indicates the current resistance setting.
The smaller the value, the weaker the resistance; the larger the value, the stronger the
resistance.
(Minimum value is 0; the maximum value is 10. The default setting is 4.)
Move the cursor to UP or DOWN and press the TEST Button to change the value.
Verifies the STEERING motor is working properly.
Toggle between OFF and ON by aligning to CENTER and pressing the TEST Button.
The STEERING will rotate and stop in the center position. Pressing the SERVICE Button
moves the cursor to the next menu item and CENTER changes to OFF. Control of the
STEERING is then released.
When the RIGHT menu item is ON, the STEERING rotates to the right as far as possible
and then stops. Press the SERVICE Button again to turn it OFF and release control of the
STEERING.
When the LEFT menu item is ON, the STEERING rotates to the left as far as possible and then
stops. Press the SERVICE Button again to turn it OFF and release control of the STEERING.
FORCE= XX
�P
DOWN
FORCE TEST (FORCE= 4) 4) )
CENTER OFF
RIGHT OFF
LEFT OFF
EXIT