Table of Contents
Advertisement
Sounds are emitted and
the lamps are lit, but the
screen is black.
Irregular/uneven colors
on the monitor screen.
Colors on the monitor
17
screen are strange.
The on-screen image
sways and/or shrinks.
Does not accept input
from any switch or
volume.
Does not accept input
from the Shift Lever.
Steering (Servomotor)
response is incorrect.
No response from
Steering (Servomotor).
Steering (Servomotor)
is weak in its force
feedback.
92
Faulty connections for the visual
signal connector or the monitor power
connector.
Broken monitor.
Magnetization to the CRT.
Faulty connection for the visual signal
connector.
Screen adjustment is not appropriate.
The power source and voltage are no
correct.
Faulty connector connections.
Faulty connector connections.
Broken Microswitch.
Incomplete power on check.
Deviation of the volume value.
Volume gear engagement fault.
Volume malfunctioning.
Detached wires.
Failure of power-on checking
procedure.
Faulty connector connections.
Thermal element in the Servodriver is
operating.
Momentary overload caused a fuse on
the Servodriver to blow.
Aging of the force feedback
mechanism.
Check the connections for the monitor
and game board connectors.
Contact the company from whom the unit
was purchased.
Press the Demagnetization switch on the
switch unit. <See Chapter 9.>
Check the visual signal connector
connection and make sure it is secured
properly.
Make adjustment appropriately.
<See Chapter 14.>
Make sure that the power supply and
voltage are correct.
Check the connection for the I/O Board
and Cabinet connector.
Check the power for the I/O Board.
Check the connections for the connectors
in the Control Panel and between the
Control Panel and the Cabinet.
Replace the Microswitch.
<Microswitch 509-5704>
Power on and verify that the power on
check completes properly.
<See Section 6-5.>
Adjust the volume value in the Test
Mode. <See Chapter 9.>
Adjust the engagement of the gear.
<See Chapter 9, 10.>
Replace the volume. <See Chapter 10.>
Check for faulty wire connections around
moving parts.
When replacing wires, secure them so
that they do not touch any moving parts.
Reconnect the power and complete a
power-on checking procedure.
<See Section 6-6.>
Check the connections for the connectors
between the Game Board and Servodriver
and between the Servodriver and the
Servomotor.
Occurs when the internal temperature
reaches 70°C (158°F) and corrects
automatically when the unit cools.
Contact the company from whom the unit
was purchased.
Reset in the Test Mode. <See Chapter 9.>
Advertisement
Table of Contents
