Table of Contents
Advertisement
Replacing the Volume
1
Switch off the unit.
2
Remove the two screws and lift off the potentio cover.
POTENTIO COVER
3
Detach the connector from the volume to be replaced.
4
Remove the single screw that secures the potentiobase (see 12-1 FIG. 02).
5
Without detaching the volume, remove the potentiobase (see 12-1 FIG. 03).
6
Remove the base and gear from the volume, and replace it.
7
After replacement, configure the volume as described above in "Adjusting Procedure"
8
When you have finished, check that the values change smoothly in response to pedal input.
12-1 FIG. 03
TRUSS SCREW (2), chrome
M4x8
POTENTIOBASE
12
69
Advertisement
Table of Contents
