Sega -RaceTV Owner's Manual page 34

6-4 TURNING POWER ON - SOFTWARE INSTALLATION
• The software is not installed on the game board (LINDBERGH RED) when the power
supply is engaged, so the "Error " message is not a malfunction.
However, if there is another error display, or if there is no video output at all, there
might have been an error in product assembly, wiring connections might be faulty, or
the LINDBERGH RED might not be functioning properly.
• After the power supply is engaged, wait for "Error " message to be displayed.
If the product is indiscriminately operated in any way beforehand, there could be
unexpected problems or malfunctions, as well as damage to parts.
• Once "Error " is displayed, set the DVD-ROM in the DVD DRIVE and re-engage the
power supply. Installation takes place.
• After the power supply is engaged, the DVD DRIVE tray will not come out for about 0
seconds even if you press the switch. This is due to DVD DRIVE initialization.
• The DVD DRIVE tray can come out or return only while the power supply is engaged.
The tray cannot be opened or closed while the power is off.
• Even after the software has been installed, store the DVD software kit, DVD DRIVE and
DVD wire in a secure location.
• If for any reason installation cannot be completed, an error is displayed. Refer to the
service manual and take corrective action.
Take out the DVD Software Kit provided
1
• Switch ON the MAIN POWER Switch on the AC Unit.
2
• The LINDBURGH starts up and an image appears on the screen (However, this may
take several minutes depending on the type of display used), then an ERROR will occur.
Check that it is "ERROR " and proceed to the next operation. If it' s not "ERROR "
take corrective measures as indicated in the LINDBURGH Service Manual.
SOFTWARE INSTALLATION
.

7