Error Messages - Sega Let’s Go ISLAND! Owner's Manual

92
ERROR MESSAGE
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
DISPLAY
CAUSE
COUNTERMEASURES
19
DISPLAY
CAUSE
COUNTERMEASURES
Error 1001
There is an error in the COIN ASSIGNMENTS SETTINGS.
COIN ASSIGNMENTS SETTINGS are incorrect.
Make sure "SYSTEM TEST MODE" > "COIN ASSIGNMENTS" > "COIN CHUTE
TYPE" and "SERVICE TYPE" are both set to "COMMON."
Error 1003
There is an error in the GAME COST SETTINGS.
"GAME COST SETTING" is incorrect.
Check "SYSTEM TEST MODE" > "COIN ASSIGNMENTS" > "GAME COST
SETTING" and make sure the 2P play cost is not set higher than the 1P play cost.
Error 1011-1
The 1P "CONTROLLER CALIBRATION SETTING" (X-axis direction) is not
configured properly.
Refer to 13-1-1 "TOP VOLUME ADJUSTMENT" and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
Error 1011-2
The 2P "CONTROLLER CALIBRATION SETTING" (X-axis direction) is not
configured properly.
Refer to 13-1-1 "TOP VOLUME ADJUSTMENT" and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
Error 1012-1
The 1P "CONTROLLER CALIBRATION SETTING" (Y-axis direction) is not
configured properly.
Refer to 13-2-1 "SIDE VOLUME ADJUSTMENT" and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
Error 1012-2
The 2P "CONTROLLER CALIBRATION SETTING" (Y-axis direction) is not
configured properly.
Refer to 13-2-1 "SIDE VOLUME ADJUSTMENT" and adjust the volume. If the
error persists, it is likely a faulty volume. Replace the volume.
Error 6001
Unable to recognize SEAT MOTOR DRIVE BD.(PITCH)
SEAT MOTOR DRIVE BD (PITCH) is not recognized.
Check to make sure the test works under "GAME TEST MODE" > "CABINET
SETTING" > "SEAT MOTION TEST."
If the test does not work, check the connection of the wires between the RINGWIDE
and SEAT MOTOR DRIVE BD (PITCH) or replace them. If the test still does not
work after replacing them, it is likely a faulty SEAT MOTOR DRIVE BD (PITCH).
Contact your point of purchase or the office listed in this manual.