Sega -RaceTV Owner's Manual page 70

10-2 ADJUSTING/REPLACING THE VOLUME
Replacement Procedure
When replacing the volume, you will also need to prepare three lengths of heat-shrinkable tubing
(Part No.: 310-5029-F20), as well as use the wires that are already soldered onto the volume. For
this task, you will need a Phillips-head screwdriver (for M4 screws), a 2 mm hexagon wrench, an
11 to 12 mm adjustable wrench, wire cutter, knife, wire stripper, soldering iron, and work dryer.
1
With the Control Panel removed from he machine, remove the Volume Control's connector.
2
Remove the two screws that secure the VR bracket and lift out the volume with the bracket.
3
Loosen the two Hexagon socket screws on the Gear Holder, and remove the Gear Holder.
4
Remove the nuts that secure the VR bracket, and detach the volume from the VR bracket.
(See 10-2 FIG. 02)
10-2 Fig 02
5
Using wire cutters or a knife, remove the heat-shrinkable tubing that covers the soldered
parts. Melt the solder with a soldering gun, and detach the volume from the wires.
6
Cover each wire separately with the heat-shrinkable tubing.
7
Solder the wires to each of the new volume's terminals. Carefully check the wiring sche-
matic when connecting the wires to the volume.
8
Cover the soldered parts with heat shrinkable tubing, and use the dryer to apply heat until
the tubing adheres to the soldered parts.
9
Re-attach the VR bracket and gear holder to the volume.
10
Refit the VR bracket to the control panel and repeat the sequence on the previous page
'Adjustment Procedure'.
10
63