Sega -RaceTV Owner's Manual page 100

The accelerator or
brake does not perform
appropriately.
Start button and View
Change button input
does not work and they
do not flash.
Start button and View
Change button input
works, but they do not
flash.
Failure of the network
play.
Circuit Protector
Functions due to the activation of bimetal. To restore the function, wait for approximately one minute or longer until
the bimetal cools off. (Press the Button.)
Incorrect volume setting.
Faulty Volume attachment or adjust
gear alignment.
Faulty connector connection.
Failure of the volume.
Faulty connector connections.
Unverified settings or operation.
The lamp is burnt out.
Network play is wrongly set.
Communication cables are
disconnected.
Communication cables are wrongly
connected.
Damage of communication cables.
CIRCUIT PROTECTOR
17 FIG. 01
Adjust the volume value in the Test
Mode. <See Chapter 9.>
Adjust the volume attachment and verify
in Test Mode. <See Chapter 9, 12.>
Check the connections for the accelerator
and brake connectors and the connectors
between the accelerator, brake and
cabinet.
Replace the volume. <See Chapter 12.>
Check the connections for the connectors
between the I/O Board, the cabinet and
the control panel and those inside the
control panel.
The Start button only flashes when Free
Play is set. Check the operation in Test
Mode. <See Chapter 9.>
Replace the lamp. <See Chapter 15.>
Reset correctly. <See Chapter 9, 19.>
Reconnect the cables. <See Chapter 19.>
Reconnect the cables correctly.
Replace the cables. Contact the company
from whom the unit was purchased.
17
93