Attaching The Dvd Drive And Key Chip - Sega -RaceTV Owner's Manual

6-2 ATTACHING THE DVD DRIVE AND KEY CHIP
PLEASE NOTE: The software is already loaded on to LINDBERGH and the KEY CHIP fitted at the factory. IF
there is a problem with the software or LINDBERGH, then the following information is provided to re-load
software on to replaced LINDBERGH. ADVD drive is availavle from STS.
1
Remove the two 'TRUSS SCREWS' , one from each side of the Lid.

2
Unlock the 'BASE' with the 'MASTER KEY' .
3
Turn the 'LOCK HANDLE, to the right to unlock the Lid..
4
Carefully lift up the LID and swing it over, gently lowering the back of the 'Driv-
ers Seat' down onto the floor. Before doing this place a piece of cloth onto the
floor where the back of the 'Driver Seat' will touch, to prevent 'Damage' to the
'Seat Back' .
5
Remove the 'KEY CHIP' from the 'DVD' Software Kit, and insert the Key Chip
into the 'LINDBERGH' . At this point, make sure to insert the Key Chip in
the right direction and pushed all of the way in. At this time also attach the
'IDENTITY STICKER' to the Lindburg.
0
(See - Fig 0)
(See - Fig 07)