Table of Contents
Advertisement
REFERENCES
RS-232/USB COM PARAMETERS
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and
the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec-
onds in 10ms increments. A setting of zero specifies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Go to
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
This completes the procedure. See the following table for examples of how to set this
feature.
Table 10 - Intercharacter Delay Setting Examples
STEP
1
Divide by 10 (pad with leading
2
zeroes to yield two-digits)
3
4
Scan two characters from
5
Appendix G
6
316
POWERSCAN™ PD/PM/PBT9600
with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
and scan the bar code: SELECT INTERCHARACTER DELAY SETTING.
page 50
duration which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION
Desired Setting
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCHARACTER DELAY SETTING
Scan ENTER/EXIT PROGRAMMING MODE
Appendix G
EXAMPLES
50ms
150ms
05
10
'0' and '5' '1' and 5'
, that represent the
600ms
850ms
60
85
'6' and '0'
8' and '5'
Advertisement
Table of Contents
