To Set The Oscilloscope To A Known Starting Condition - Keysight Technologies Infiniium 90000A Series User's Quick Start Manual

Using the Oscilloscope

To set the oscilloscope to a known starting condition

To set the oscilloscope to a known starting condition
• Press the Default Setup key.
You can set up the oscilloscope for many different kinds of complex
measurements. To easily reset the oscilloscope to a known measurement
configuration, use the Default Setup key.
If you use the Default Setup key, you can select Undo Default Setup from the
Control menu to return the oscilloscope to its original configuration.
Save the Current Oscilloscope Configuration
Before using Default Setup, you may want to save the current oscilloscope
configuration for later use. See the built-in information system (described in
chapter 4) for instructions on saving and recalling setups, and for information on
the exact configuration that is set when you press Default Setup.
3-8