Table of Contents
Advertisement
To adjust vertical scaling
• To make the waveform bigger, click on the larger waveform button next
to the channel number near the top of the display. To make the
waveform smaller, click on the smaller waveform button.
See figure 3-28. The number of volts per division decreases.
The number of volts per division increases. The current setting in volts per
division is shown next to the waveform buttons for the channel. Notice that the
setting is color-coded to match the waveform color for easy recognition.
You can also adjust the vertical scaling by clicking on the current setting, which
is shown next to the waveform buttons for the channel. This displays a pop-up
numeric keypad that allows you to set an exact value for the scaling. Or, you
can adjust the vertical scaling through the Channel Setup dialog box. See "To
access the channel setup" on page 3-44.
Figure 3-28
Click to display a pop-up
numeric keypad that lets
you specify a particular
vertical scaling value
Adjusting Vertical Scaling
Using the Oscilloscope
To adjust vertical scaling
Click to make the
waveform bigger
(fewer volts per
division)
Click to make the
waveform smaller
(more volts per
division)
3-43
Advertisement
Table of Contents
