Setting Up the Oscilloscope
To verify basic operation for the 90000A series oscilloscope
The display will pause momentarily while the oscilloscope is configured to its
default settings.
4 Press the Autoscale key on the front panel.
The display will pause momentarily while the oscilloscope adjusts the sweep
speed and vertical scale. You should then see a square wave with peak-to-peak
amplitude of approximately 5 divisions and a shows about four cycles on screen.
If you do not see the waveform, ensure your power source is adequate, the
oscilloscope is properly powered-on, and the probe is connected securely to the
front-panel channel input BNC and to the probe calibration output.
5 Move the mouse around the mouse surface and verify that the on screen
pointer follows moves with the mouse movement.
6 Touch the pointer of the touch screen stylus to the surface of the screen
and move it around while verifying that the pointer follows the
movement.
1-24