To Set The Oscilloscope To Trigger On An Edge - Keysight Technologies Infiniium 90000A Series User's Quick Start Manual

To set the oscilloscope to trigger on an edge

1 Press and release the Mode key until the Edge LED indicator is
illuminated.
2 Press and release the Source key until the desired source LED is
illuminated.
You can choose any of the channels, the Aux, or Line as the source for an edge
trigger.
3 Press the Slope key until the desired slope LED is illuminated.
You can have an edge trigger on a rising or falling edge.
4 Press the Sweep key until the Trig'd LED is illuminated.
The oscilloscope will wait for the edge before initiating a sweep.
5 Turn the Level knob to adjust the voltage level at which the oscilloscope
will trigger.
Figure 3-8
Select Edge
mode
Trigger Controls and Indicators for 90000A Series Oscilloscopes
To set the oscilloscope to trigger on an edge
Select rising
Select the
or falling
Select Trig'd or
trigger
edge for the
Auto
source trigger
Using the Oscilloscope
Set trigger level
Set the sensitivity
characteristics for the
trigger
3-15