Precautions When Moving The Machine - Sega AFTER BURNER CLIMAX Owner's Manual

PRECAUTIONS WHEN MOVING THE MACHINE


• Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing fire or
electric shock.

• To move the unit over the floor, pull in the adjustors and have the casters
contact the floor. While moving the unit, be careful that the casters do not roll
over the power cord or the ground wire. If cord or wire is damaged, there could
be electrical shocks and/or short circuits.
• To lift up the cabinet, hold it at the bottom. If you hold it anywhere else, the
weight of the cabinet could cause damage to parts or attachments, resulting in
injury.
• To install this product, the entrance must be at least 1.3 m in width and 1.95 m in
height. If the entrance is too narrow, do not tilt the product carelessly. If all the
product weight is put on the casters at one side only, there could be damages
or deformations, causing serious accidents such as workers getting caught
underneath.
• If the unit cannot be taken through the entrance, do not disassemble it
indiscriminately. Do not disassemble the unit in any way other than as instructed
in this manual. Disassembly and assembly of mechanical components require
special tools and adjustment procedures. Indiscriminate disassembly could
result in electrical shocks, short circuits, or accidents while working on or
operating the unit, leading to injuries.
Do not hold or press the plastic parts as indicated by the figure. Failure to observe
this instruction may break the parts, and eventually the broken pieces may cause
a personal injury.
0