Operation Area - Sega AFTER BURNER CLIMAX Owner's Manual



- OPERATION AREA

• For the operation of this machine, secure a minimum area of 2.1 m (W) x 2.18
m (D). The dimensions of the base periphery are established in consideration of
ventilation, maintenance and customer passage. With this product there is the
danger that someone could fall down while getting onto the base or the seat.
And if they fall and hit their head, there could be a very serious injury. Be sure to
always secure enough space as prescribed in this manual.
• Be sure to provide sufficient space specified in this manual. Do not allow objects
to block the ventilation ports. It can cause generation of heat and a fire.
• SEGA shall not be held responsible for damage or compensation for damage to
a third party, resulting from the failure to observe this instruction.
• If the machine does not fit through the entryway to the installation location, do
not disassemble it without first consulting the instructions. The machine should
only be disassembled in accordance with the instructions listed in this manual;
do not attempt to disassemble it in any other way. Specific tools and adjustment
procedures are required to assemble and disassemble the mechanical parts.
Attempting to assemble or disassemble the machine without consulting the
instructions may result in accidents during assembly/disassembly and electric
shock, short circuits, and/or personal injury during operation. If the machine still
does not fit through the entryway after following the procedures in this manual,
contact your retailer or the office listed in this manual.
• If the machine is still too large to fit through the entryway after following the
procedures listed in this manual, do not tip the machine on its side. Attempting
to transport the machine while it is tipped on its side may cause accidents. It
may also damage or warp parts of the machine, resulting in accidents during
operation.
• To install this product, the entrance must be at least 1.3 m in width and 1.95 m in
height. If the entrance is too narrow, do not tilt the product carelessly. If all the
product weight is put on the casters at one side only, there could be damages
or deformations, causing serious accidents such as workers getting caught
underneath.

Electricity Consumption:
MAX. 6.30 A (AC 120 V, 60 Hz)