Sega ALL AIR TRIX DLX Service Bulletin

Download this manual

SPECIAL NOTICE FOR

ALL AIR TRIX DLX

Stoppers, over period of time, allow too much roll motion of skateboard causing

PROBLEM:

damage to potentiometer.

Install Stopper Base ATR-3114 (4 pieces) and Sub Stopper ATR-3115 (4 pieces)

SOLUTION:

to existing stoppers.(See Following Procedure)

Sub Stopper

ATR-3115

Stopper Base

ATR-3114

Not following the directions provided herein may cause your game to malfunction.

All electrical work should be performed by the site's Serviceman or Technician.

If you have any questions, please contact the SEGA Service Department at the numbers given above.

SERVICE BULLETIN

SEGA Service Department

45133 Industrial Drive

Fremont, Ca. 94538

After Installation

Apr 17. 2001

http://www.seuservice.com

Phone: 415.701.6580

Fax: 415.701.6594

131

Page

1 of 4

Page 1 Not following the directions provided herein may cause your game to malfunction. All electrical work should be performed by the site’s Serviceman or Technician. If you have any questions, please contact the SEGA Service Department at the numbers given above.
Page 2 PARTS REPLACEMENT PROCEDURE FOR AIR TRIX Page 2 of 4 Stopper reinforcement parts. (PHOTO 2.1) Install these 2 parts. (SUPPLIED) STOPPER BASE ATR-3114 4 pieces SUB STOPPER ATR-3115 4 pieces (USE RTV SILICONE TO SECURE PARTS) SUB STOPPER ATR-3115 STOPPER BASE ATR-3114 PHOTO 2.1 Remove the screws securing the base of bellows.
Page 3 Page Secure the stopper base onto stopper with a small amount of 3 of 4 silicone as pictured. (PHOTO 2.3) STOPPER BASE ATR-3114 PHOTO 2.3 Secure the SUB STOPPER onto the STOPPER BASE with a small amount of silicone, assure chamfer faces up as shown.
Page 4 Repeat for opposite side. (Install Stopper Base & Sub Stopper) (PHOTO 2.5) Page 4 of 4 PHOTO 2.5 NOTE: Be careful to not get injured by the screws, for wiring, underneath the rolling base. (Two pieces on leftside of board.) (PHOTO 2.6) SCREWS FOR WIRING PHOTO 2.6 Route wire harness as pictured to avoid problems.