Roll Volume Adjustment Or Replacement - Sega AFTER BURNER CLIMAX Owner's Manual

1- ROLL VOLUME ADJUSTMENT OR REPLACEMENT

When seat movement is unsatisfactory and settings on the test mode calibration screen are ineffective, the problem
could be faulty volume gear mesh, volume malfunction or an anomaly in a moving mechanical component.
With this product, when the seat has been tilted fully to the right or left, if the volume rotary shaft turns within its
movable range, there is no danger that the volume will be damaged.
1
When the seat is level, fasten it so that the volume shaft is in the prescribed direction and the gear mesh fits properly.
The following tools are required for the following procedure.
- Philips screwdriver for M4 screw
- Flat head screwdriver for M3 screw
- 2.5 mm Allen wrench or screwdriver
- 11 to 12 mm spanner
- Nippers
- Cutter
- Soldering iron
- Industrial drier
Adjustment Method
1
Cut off the power supply.

Remove front pillar cover. Remove 1 truss screw and 2 hexagon socket screws. (See 13-1.)

Remove 2 screws that hold down the roll volume bracket, then remove the bracket together with the volume.
FIG. 13-2a
1