Throttle Lever - Sega AFTER BURNER CLIMAX Owner's Manual

THROTTLE LEVER

1
• When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
• Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of fire.
• Do not touch any parts that are not specified in these directions. Touching
unspecified locations may lead to electric shock or cause short circuits.
• This work should be performed by site maintenance personnel or other skilled
professionals. Work performed by non-technical personnel can cause a severe
accident such as an electric shock.
• Exercise due caution in performing soldering procedures. If soldering iron is
handled carelessly, there could be fires or burns.
• Proceed very carefully when heating thermal contraction tube. Careless
operations can result in fires or burns.
• In performing adjustments or replacements, check the surroundings before
powering up. The product undergoes initialization automatically after the power
has been engaged. If someone is near the product and the seat moves left or
right, there could be a collision or fall.
When fastening plastic parts, be careful not to tighten screws and nuts excessively.
Otherwise parts may be damaged, resulting in injuries from fragments, etc.
After the volume has been replaced, be sure to set the volume value on the test
mode calibration screen and the input test screen and check variations in the
volume value.
If the operability of the throttle lever is unsatisfactory, or if the lever is ineffective with the settings on the test mode
calibration screen, the problem could be faulty gear mesh or volume malfunction.
Grease the mechanical component of the throttle lever once every 3 months.
1
111