1- VOLUME ADJUSTMENT OR REPLACEMENT
When the volume that detects throttle lever operation is unsatisfactory, either adjust the gear mesh or replace the
volume by proceeding as follows.
With this product, when the lever has been operated fully to front or rear, if the volume rotary shaft turns within its
movable range, there is no danger that the volume will be damaged. With your hand released from the lever, fasten
the volume so that the gear fits properly with the volume shaft in the designated direction.
1
The following tools are required for the following procedure.
- Philips screwdriver for M4 screw
- 2 mm Allen wrench or screwdriver
- 11 to 12 mm spanner
- Nippers
- Cutter
- Soldering iron
- Industrial drier
Adjustment Method
1
Cut off the power supply.
Take out the 4 truss screws and remove throttle cover lower. (See 12-1.)
Loosen the 2 screws that hold down the VR bracket.
11
FIG. 12-2a