Volume Replacement - Sega AFTER BURNER CLIMAX Owner's Manual

11- VOLUME REPLACEMENT

If control stick operability is unsatisfactory and settings on the test mode calibration screen are ineffective, the
problem could be a malfunction of the control stick volume.
Remove the control stick and replace the volume.
Please note, however, that the control stick has two volumes. Make sure you are replacing the correct volume.
Have available a volume for replacement and three thermal contraction tubes (PART NO. 310-5029-D12).
11
Use the following tools and solder.
- 2.5 mm Allen wrench or screwdriver
- 8 mm spanner, Allen screwdriver or socket wrench
- Philips screwdriver (for M3 screw)
- 11 to 12 mm spanner
- Nippers
- Cutter
- Wire stripper
- Soldering iron
- Industrial drier
1
Cut off the power and remove the control stick. (See 11-1.)

Take out the 2 screws that hold down the volume bracket.
10
FIG. 11-3a