Greasing - Sega AFTER BURNER CLIMAX Owner's Manual

After the volume has been replaced, be sure to set the volume value on the test
mode calibration screen and the input test screen and check variations in the
volume value.
1
The volume that detects seat inclination is the roll volume. It is inside the front pillar cover.

1-1 GREASING

• Be sure to use the designated grease. Using undesignated grease can cause
parts damage.
• Do not apply grease to locations other than as specified. Doing so may create
a risk of operational problems and deterioration of parts.
• The designated periods for greasing serve only as a guide. Whenever there are
squeaks or other anomalies, apply grease at designated locations.
Once every 3 months, grease the gear mesh that rotates the volume shaft. Use Greasemate (PART NO. 090-0066).
1
Cut off the power supply.

Remove the front pillar cover at the back of the CRT. There are 2 types of fastening screws. Remove 1 truss
screw from the top. A flat washer is used with the truss screw.
10
FIG. 13-1a