Network Cable Connections - Sega AFTER BURNER CLIMAX Owner's Manual

0- NETWORK CABLE CONNECTIONS

To setup network play, connect the two game machines for network play with a network (LAN) cable. Do not
connect a network cable to any game machine not being used for network play.
Have available the accessory network cable, Philips screwdriver for M4 screws, and a 24 mm spanner.
1
Cut off the power and pull the power plug from the outlet. Remove the power cord so it will not be damaged
while working.

Align the game units left and right. In order to perform the following work, establish work space on the AC
unit side. When aligning the machines, either hold the base or push it. Do not pull or push on the seat or
gondola, the control stick or throttle lever. (See chapter 7.)

Loosen 2 truss screws that hold down the LAN lid of the AC unit in the two game machines.
FIG. 20-2a

When the LAN lid is raised, you see a port. While the port is visible, tighten the 2 truss screws that were
loosened in order to fasten the LAN lid.
FIG. 20-2b
0
1