Replacing The Fluorescent Lamps - Sega AFTER BURNER CLIMAX Owner's Manual

REPLACING THE FLUORESCENT LAMPS

1
• When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
• You may get burned by a hot fluorescent lamp or other lamps. Pay full attention
to the lamps when performing the work.
• There is the danger of short circuits or smoke generation due to deterioration
of insulation in lighting fixtures resulting from age deterioration. Check for
anomalies such as the following: Does it smell like something is burning? Is there
socket discoloration? Are any lamps being replaced frequently? Do lamps not
go on properly?
• Before turning on the power after a fluorescent lamp has been replaced,
inspect carefully to see if anyone is near the product or if tools or other items
have been left on the product. When the power is turned on, initialization takes
place automatically. If anyone is near the product, they could collide with the
product or come in contact with it accidentally. Accidents could also occur if
tools or other items fly off the product.
• Be careful when handling the plastic parts. Failure to observe this may cause
injury or damage due to fragments, etc.
• Do not attempt to replace billboard fluorescent lamps while standing on the
base. If you should misstep while working, you could stumble or fall down.
1
1