Installing The Rear Mounting Front Perc Module - Dell EMC PowerEdge R650 Installation And Service Manual

Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 41. Removing the rear mounting front PERC module
Next steps
1. Replace the rear mounting front PERC

Installing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air
5. Remove the drive backplane.
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors on the front PERC module with the connectors on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
52 Installing and removing system components
module.
Safety instructions.
Before working inside your
cover.
shroud.
system.