Table of Contents
Advertisement
2. Slide the rear mounting front PERC module to disengage from the connector on the drive backplane.
Figure 67. Removing the rear mounting front PERC module
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the cooling fan cage
4.
Remove the drive backplane
5. If required,
remove the air shroud
6. Route the cable properly to prevent the cable from being pinched or crimped.
NOTE:
Refer to
cable routing
Steps
1. Align the connectors and guide slots on the rear mounting front PERC module with the connectors and guide pins on the
drive backplane.
2. Slide the rear mounting front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the rear mounting front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Safety
instructions.
Before working inside your
assembly.
cover.
or
remove the GPU air
section for more information.
system.
shroud.
Installing and removing system components
91
Advertisement
Table of Contents
