Installing The Ocp Card - Dell EMC PowerEdge R650 Installation And Service Manual

Figure 108. Removing the OCP card
Next steps
1. Replace the OCP card.

Installing the OCP card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
Steps
1. Open the blue latch on the system board.
2. Slide the OCP card into the slot in the system.
3. Push until the OCP card is connected to the connector on the system board.
4. Close the latch to lock the OCP card to the system.
Safety instructions.
Before working inside your
riser.
system.
Installing and removing system components 123