Removing The Left Control Panel; Installing The Left Control Panel - Dell EMC PowerEdge R650 Installation And Service Manual

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
4. If installed, remove the air
Steps
1. Disconnect the control panel cable from the connector on the system board.
2. Lift the latch to release the control panel cable and slide the cable from the clip.
NOTE: Observe the routing of the cable as you remove it from the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel to the system.
4. Hold the left control panel cable, and slide the left control panel out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 135. Removing the left control panel
Next steps
1. Replace the left control

Installing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Safety instructions.
Before working inside your
cover.
shroud.
panel.
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 149