Removing The Expansion Card Risers - Dell EMC PowerEdge R650 Installation And Service Manual

Table 44. Riser configuration 6: R3A + R1D Paddle card (continued)
Card type
Qlogic (HBA: FC 32)
Qlogic (HBA: FC 16)
Qlogic (NIC: 10 Gb)
Qlogic - Marvell (NIC: 10 Gb)
Broadcom (NIC: 10 Gb)
Intel (NIC: 10 Gb)
Broadcom (NIC: 1 Gb)
Intel (NIC: 1 Gb)
Mellanox (NIC: HDR100 VPI)
Mellanox (NIC:HDR VPI)
Marvell (OCP: 25 Gb)
Mellanox (OCP: 25 Gb)
SolarFlare (OCP: 25 Gb)
Broadcom (OCP: 25 Gb)
Intel (OCP: 25 Gb)
Broadcom (OCP: 10 Gb)
Intel (OCP: 10 Gb)
Qlogic (OCP: 10 Gb)
Broadcom (OCP: 1 Gb)
Intel (OCP: 1 Gb)
GPU / Others
Inventec (Serial)
NOTE: The system supports either BOSS-S1 or BOSS-S2. It cannot support both the cards together.

Removing the expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect any cables that are connected to the expansion card.
Steps
1. For Riser 1, press the blue tab and holding the edges lift the expansion card riser from the riser connector on the system
board.
94 Installing and removing system components
Safety instructions.
Before working inside your
Slot priority
3
3
3
3
3
3
3
3
3
3
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
Integrated slot
3
system.