Installing The M.2 Ssd Module - Dell EMC PowerEdge R650 Installation And Service Manual

Figure 90. Removing the M.2 SSD module
Next steps
1. Replace the M.2 SSD

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the BOSS card. Removing BOSS card is similar to
Steps
1. Align the M.2 SSD module at an angle with the BOSS card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card with the screw.
module.
Safety
Before working inside your
instructions.
system.
removing expansion card from the expansion card
Installing and removing system components
riser.
109