Installing A Power Supply Unit Blank - Dell EMC PowerEdge R650 Installation And Service Manual

Steps
Pull the blank out of the system.
CAUTION: To ensure proper system cooling, the PSU blank must be installed in the second PSU bay in a
non-redundant configuration. Remove the PSU blank only if you are installing a second PSU.
Figure 120. Removing a power supply unit blank
Next steps
Replace the PSU or PSU

Installing a power supply unit blank

Prerequisites
1. Follow the safety guidelines listed in the
NOTE: Install the power supply unit (PSU) blank only in the second PSU bay.
2. Remove the PSU.
Steps
Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
Figure 121. Installing a power supply unit blank
134 Installing and removing system components
blank.
Safety instructions.