Figure 86. Removing the R1 paddle card
Next steps
1.
Replace the paddle
cards.
Installing R1 paddle card
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in
Before working inside your
system.
3. If
installed,remove the air
shroud.
4. Remove the paddle card cable from side wall bracket.
5. Disconnect the paddle card cables from the drive backplane.
Steps
1. Holding the edges, align the hole on the paddle cards with the guides on the system board.
2. Lower the paddle cards into place and press until the paddle card connector is fully seated on the system board connector.
Installing and removing system components
105