Removing A Memory Module - Dell EMC PowerEdge R650 Installation And Service Manual

Table 34. Intel Persistent Memory 200 series (BPS) Configuration 6 - 12 x RDIMMs/ LRDIMMs, 2 x Intel
Persistent Memory 200 series (BPS) per processor (continued)
Total No of Total No of
RDIMMs / Intel
LRDIMMs Persistent
Memory 200
series (BPS)
DIMMs
12 2
12 2

Removing a memory module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
WARNING: The memory modules are hot to touch for some time after the system has been powered off. Allow
the memory modules to cool before handling them.
NOTE: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not
occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.
NOTE: DIMM blanks to be removed for partial configurations with EXT heat sink having CPU TDP > 165 W.
Steps
1. Locate the appropriate memory module socket.
2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module
socket to fully open.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the
memory module or metallic contacts.
3. Lift the memory module away from the system.
1 R/LRDIMM 1 Intel
capacity (GB) Persistent
Memory 200
series (BPS)
capacity (GB)
128 512
256 512
Safety instructions.
Before working inside your
Total Standard
Memory Capacity
(GB)
1536
3072
system.
Installing and removing system components
Total PM Supported Modes
Capacity
(GB)
1024 AD
1024 AD
69