Dell EMC PowerEdge R650 Installation And Service Manual page 125

Figure 110. Removing the system battery
2. To install a new system battery:
a. Hold the battery with the positive side facing up and slide it under the securing tabs.
b. Press the battery into the connector until it snaps into place.
Figure 111. Installing the system battery
Next steps
1. Install the expansion card
2. If applicable, connect the cables to one or more expansion cards.
3. Follow the procedure listed in
4. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
risers.
After working inside your system.
Installing and removing system components 125