System Board; Removing The System Board - Dell EMC PowerEdge R650 Installation And Service Manual

Figure 127. Installing the serial COM port
Next steps
1. Install the expansion card
2. Follow the procedure listed in

System board

This is a service technician replaceable part only.

Removing the system board

Prerequisites
CAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted
to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key.
If you replace this system board, you must supply the recovery key when you restart your system or program
before you can access the encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the following components:
a. Air shroud
b. Cooling fan modules
c. Processor and heat sink module
d. Memory modules
140 Installing and removing system components
riser.
After working inside your
Safety instructions.
Before working inside your
system.
system.