Drives; Removing A Drive Blank - Dell EMC PowerEdge R650 Installation And Service Manual

3. If installed, remove the air
Steps
1. Align and place the fan module connector horizontally with the connector on the system board.
NOTE: The procedure to remove standard (STD), high performance silver grade (HPR SLVR), or high performance gold
grade (HPR Gold) dual cooling fan modules are same.
2. Press the touch point on the cooling fan module until firmly connected.
Figure 27. Installing a cooling fan module
Next steps
1. If applicable, install the air
2. Follow the procedure listed in

Drives

Removing a drive blank

Prerequisites
1. Follow the safety guidelines listed in the
2. If installed, remove the front
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
Steps
Press the release button, and slide the drive blank out of the drive slot.
shroud.
shroud.
After working inside your
Safety instructions.
bezel.
system.
Installing and removing system components 41