System Battery; Replacing The System Battery - Dell EMC PowerEdge R650 Installation And Service Manual

Figure 109. Installing the OCP card
Next steps
1. Install the expansion card riser
2. Follow the procedure listed in

System battery

This is a service technician replaceable part only.

Replacing the system battery

Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery
only with the same or equivalent type That is recommended by the manufacturer. Discard used batteries
according to the manufacturer's instructions. See the Safety instructions. that came with your system for more
information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the power or data cables from the expansion cards.
4. Remove the expansion card
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
124 Installing and removing system components
After working inside the
Safety instructions.
Before working inside your
risers.
system.
system.