Control Panel; Removing The Right Control Panel - Dell EMC PowerEdge R650 Installation And Service Manual

Control panel

This is a service technician replaceable part only.

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the drive backplane
4. If installed, remove the air
Steps
1. Disconnect the right control panel cable from the connector on the system board.
2. Lift the latch, and slide the cable out of the clip.
NOTE: Observe the routing of the cable as you remove the right control panel from the system.
3. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel to the system.
4. Holding the cable, slide the right control panel out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 133. Removing the right control panel
Next steps
1. Replace the right control
Safety instructions.
Before working inside your
cover.
shroud.
panel.
system.
Installing and removing system components 147