Installing The Processor - Dell EMC PowerEdge R650 Installation And Service Manual

Figure 58. Lift up the TIM break lever
4. Using your thumb and index finger, first hold the carrier release tab at the pin 1 connector, pull out the tip of the carrier
release tab, and then lift the carrier partially from the heat sink.
NOTE: Ensure to return the TIM break lever back to its original position.
5. Using your thumb and index finger, first hold the carrier release tab at the pin 1 connector, pull out the tip of the carrier
release tab, and then lift the carrier from the heat sink.
6. After all the corners are released from the heat sink, lift the carrier from the pin 1 corner of the heat sink.
Figure 59. Removing the processor carrier
Next steps
Replace the processor into a processor and heat sink module

Installing the processor

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
74 Installing and removing system components
Safety instructions.
Before working inside your
(PHM).
system.