Figure 107. Installing the MicroSD card
Next steps
1.
Install the IDSDM
module.
2.
Install the air
shroud.
3. Follow the procedure listed in the
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Open the blue latch to unlock the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board and slide the
OCP card out of the slot on the system.
122
Installing and removing system components
After working inside the
Safety
instructions.
Before working inside your
riser.
system.
system.