Dell EMC PowerEdge R650 Installation And Service Manual page 128

Steps
1. Disconnect the VGA cable from the connector on the system board and open the cable latch.
2. Disconnect the right control panel cable from the system board and move it away to see the VGA module screw on the
system.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
3. Using Phillips #2 screwdriver, remove the screw on the VGA module.
4. Slide the VGA module out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
128 Installing and removing system components