Table of Contents
Advertisement
Figure 62. Removing the rear mounting front PERC module
3. Using a Phillips #2 screwdriver, remove the three screws securing the front PERC bracket to the drive backplane.
4. Lift the front PERC bracket away from the drive backplane.
Next steps
1.
Replace the rear mounting front PERC
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the drive
backplane.
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the slots on the front PERC bracket with the holes on the drive backplane.
2. Using a Phillips #2 screwdriver, replace the three screws to secure the front PERC bracket to the drive backplane.
3. Align the connectors on the front PERC module with the connectors on the drive backplane.
4. Slide the front PERC module until the module is connected to the drive backplane.
5. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
96
Installing and removing system components
module.
Safety
instructions.
Before working inside your
cover.
shroud.
system.
Advertisement
Table of Contents
