Installing The Vga Module - Dell EMC PowerEdge R650 Installation And Service Manual

Figure 114. Removing the VGA module
Next steps
1. Replace the VGA module.

Installing the VGA module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If installed, remove the front
4. Remove the backplane
5. If installed, remove the air
6. Disconnect the VGA cable from the connector on the system board.
7. Pull the right control panel cable from the clip and move it to clear the path of the VGA module screw.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Route the VGA cable through the slot on the front of the system and slide the VGA module into the slot.
2. Align the hole on the module with the screw hole on the system.
3. Using the Phillips #2 screwdriver, secure the VGA module to the system with the screw.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Safety instructions.
Before working inside your
bezel.
cover.
shroud.
system.
Installing and removing system components 129