Rear View Of The System - Dell EMC PowerEdge R650 Installation And Service Manual

Rear view of the system

Figure 7. Rear view of the system with 2 x FH PCIe slots
Table 6. Rear view of the system with 2 x FH PCIe slots
Item Ports, panels, or slots
1 BOSS S2 module blank
2 Power supply unit (PSU 1)
3
PCIe expansion card riser
(slot 1 - FH)
4
PCIe expansion card riser
(slot 2 - FH)
5 USB 2.0 port (1)
6 Power supply unit (PSU
2)
7
VGA port (on STD RIO
board)
8 USB 3.0 port (1)
9 iDRAC dedicated port
10 System identification
button
11
OCP NIC port (optional)
12 NIC port (2)
NOTE: For more information, see the Dell EMC PowerEdge R650 Technical Specifications on the product documentation
page.
Icon
N/A
N/A
N/A
N/A
Description
This slot supports the BOSS S2 module.
Indicates the PSU.
The expansion card riser enables you to connect PCI
Express expansion cards.
The expansion card riser enables you to connect PCI
Express expansion cards.
This port is USB 2.0-compliant.
Indicates the PSU.
Enables you to connect a display device to the system.
This port is USB 3.0-compliant.
Enables you to remotely access iDRAC. For more
information, see the iDRAC User's Guide at
poweredgemanuals.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
● If the system stops responding during POST, press
and hold the system ID button (for more than 5
seconds) to enter the BIOS progress mode.
This port supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
The NIC ports are embedded on the LOM card that is
connected to the system board.
Dell EMC PowerEdge R650 system overview
www.dell.com/
13