Table of Contents
Advertisement
Figure 112. Removing the rear mounting front PERC module
Next steps
Replace the rear mounting front PERC module
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan
6. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the connectors on the front PERC module with the connectors on the drive backplane.
2. Slide the front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
144
Installing and removing system components
Safety
instructions.
Before working inside your
cover.
shroud.
cage.
system.
Advertisement
Table of Contents
