Installing The Serial Com Port - Dell EMC PowerEdge R650 Installation And Service Manual

Figure 125. Installing the filler bracket
Next steps
1. Replace the serial COM

Installing the serial COM port

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Lift the expansion card riser
Steps
1. If installed, remove the filler bracket from the expansion card riser (Riser 3).
NOTE: For more information about how to remove the filler bracket, see the
expansion card riser
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
138 Installing and removing system components
port.
Safety instructions.
Before working inside your
and disconnect the serial COM port cable from the connector on the rear I/O board.
topic.
system.
Removing the expansion card from the