Connections; Transmitter Rear Panel Connections - Extron electronics DTP3 T 202 User Manual

DTP3 T 202 Front Panel
11.
12.
After the transmitter, the receiver, and their connected devices are powered up, the system
e
is fully operational. If any problems are encountered, ensure all cables are routed and
connected properly.
A

Connections

Transmitter Rear Panel Connections

DTP3 T 202 Rear Panel
POWER HDMI
12V
--A MAX
LOOP OUT
A B
Figure 2.
A
B
C
D
ATTENTION:
• The DTP3 T 202 and DTP3 R 201 devices are configured to output power to
DTP3 models only. If connected to a non‑DTP3 device, set the toggle switch
to the DOWN (OFF) position. Failure to turn the power OFF will damage the
connected device.
• Le DTP3 T 202 et le DTP3 R 201 sont configurés pour alimenter uniquement
les modèles DTP3. S'ils sont connectés à un autre type d'appareil, veuillez
positionner l'interrupteur à bascule sur « DOWN » (OFF). Si l'interrupteur n'est
pas positionné sur OFF, vous risquez d'entraîner la défaillance de l'appareil non
DTP3 connecté.
Connect power to the designated "powered DTP3 device".
SEND
Power on the source devices.
PWR HDBT INPUT
SIGNAL
CONFIG
HDCP
OFF DTP
B C D E
SIG LINK OVER
HDMI
TP
RS-232
Tx Rx
INPUT OUT
C D E
DTP3 T 202 Transmitter Connectors
Power inlet — Plug the included external 12 VDC power supply into either this 2‑pole
inlet or the power inlet on the receiver (see
Supply Wiring on page 9 to wire the connector).
NOTES:
• One power supply is included with the transmitter and can normally power
both units. Remote power is only available if both the transmitter and the
receiver are from the Extron DTP3 series.
•
The power supply can be plugged into either the transmitter or the receiver to
power both units.
Loop Out — Passes the original HDMI video signal out, unaltered, to another device.
HDMI input — Connect an HDMI cable between this port and the digital video source.
NOTE: See Securing the HDMI Connector
HDMI connectors to the transmitter and the receiver.
Output port — Connect one end of a TP cable to this RJ‑45 port on the transmitter.
Ensure the opposite end of this cable is connected to the receiver DTP3 In RJ‑45 port
(see figure 3, ).
C
Signal LED — This green LED indicates the unit is receiving a TMDS clock signal
•
on the HDMI input.
DTP3 R 201 Front Panel
e
DTP3 T 202
A
DTP3 R 201 Rear Panel Power inlet
A
Loop Out
B
POWER HDMI
12V
--A MAX
HDMI input
C
Output RJ-45 port
D
G
OUTPUT
Over TP RS-232 port
E
A B
figure 3,
A
on page 8 to securely fasten the
DTP3 T 202 / DTP3 R 201 • Installation and Operation
SEND
PWR
SIGNAL
CONFIG
HDCP
OFF
B C D
SIG LINK OVER
DTP3
RS-232
Tx Rx
DTP3 IN
C D
, on page 6, and Power
DTP
DTP3 R 201
L R
G AUDIO OUT
E
5