Reference Information; Mounting The Transmitter Or Receiver; Tabletop Use; Mounting Kits - Extron electronics DTP3 T 202 User Manual

Reference
Information
This section provides procedures for mounting the DTP3 transmitter and receiver.

Mounting the Transmitter or Receiver

ATTENTION:
The 1‑inch high, quarter rack width, 6‑inch deep transmitter and receiver can be placed
on a table, mounted in a rack, or mounted under a desk or table. The receiver can also be
mounted on a projector bracket.

Tabletop Use

Affix the included rubber feet to the bottom of the unit and place it in any convenient
location.

Mounting kits

Mount the unit using the optional compatible mounting kit listed on the Extron website, in
accordance with the directions included with the kit. The devices are compatible with the
Extron Half Rack shelf system HRB 109, Extron UTS under the table shelf system, Extron
rack shelves RSU 126, and MBU 125 under the table shelf brackets.
For rack mounting, see UL Rack‑Mounting Guidelines.
UL Rack‑Mounting Guidelines
The following Underwriters Laboratories (UL) requirements pertain to the installation of the
unit into a rack.
•
•
• Risk of property damage:
• Risque de dommages matériels :
• Installation and service must be performed by authorized personnel only.
• L'installation et la maintenance du système doivent être exclusivement
effectuées par le personnel autorisé.
Elevated operating ambient temperature — If installed in a closed or multi‑unit rack
assembly, the operating ambient temperature of the rack environment may be greater
than room ambient. Therefore, consider installing the equipment in an environment
compatible with the maximum ambient temperature (TMA = +122 °F, +50 °C) specified
by Extron.
Reduced air flow — Installation of the equipment in a rack should be such that the
amount of air flow required for safe operation of the equipment is not compromised.
DTP3 T 202 / DTP3 R 201 • Reference Information 37