Command And Response Table For Sis Commands - Extron electronics DTP3 T 202 User Manual

X(
X1!
X1@
X1#
X1$
X1%

Command and Response Table for SIS Commands

Command
Signal Status (unsolicited)
Request all signal status (Tx)
Request all signal status (Rx)
X!
= Signal status 0 = Off/Disabled
KEY:
HDCP Status (unsolicited)
View input HDCP status
View output HDCP status (Tx)
View output HDCP status (Rx)
KEY:
X&
= Input HDCP Status
X*
= Output HDCP Status
HDCP Authorized Device (Tx only)
HDCP authorization enable/
disable
HDCP authorization status
X!
= Authorization status
KEY:
= HDCP output mode
1 = Encrypt as required by input. Continuous trials for HDMI sinks, attempt for 10s on
DVI sinks (then fail). (Default)
2 = Always encrypt. Continuous trials for HDMI sinks, attempt for 10s on DVI sinks (then fail).
= 128 or 256 Byte EDID raw HEX (text form) from currently assigned EDID.
= Native resolution and refresh rate from currently assigned EDID, for example: 1920x1080
@ 60 Hz.
= 5V output mode
1 = Auto (5V enabled when source with 5V present, else off)
2 = 5V always enabled (default)
= DTP/HDBT switch status
1 = DTP mode
2 = HDBT mode
= Password: Maximum length is up to 128 characters. All human‑readable characters are
except "|". Passwords are case‑sensitive and cannot be a single space.
ASCII Command
(host to unit)
E
LS }
Verbose mode 2/3
E
LS }
Verbose mode 2/3
1 = On/Enabled
E
}
IHDCP
Verbose mode 2/3
E
OHDCP }
Verbose mode 2/3
E
OHDCP }
Verbose mode 2/3
0 = No video/source detected
2 = Video/source detected, with HDCP
0 = No sink detected
2 = Sink detected, output HDCP encrypted
E X!
E HDCP }
E
EHDCP }
Verbose mode 2/3
0 = Disabled 1 = Enabled (default)
Response
(unit to host)
X! X! X!
•
* ]
X! X! X!
•
Sig * ]
X! X!
* ]
X! X!
]
Sig *
X&
]
X&
HdcpI ]
X* X*
•
]
X* X*
HdcpO • ]
X*
]
X*
]
HdcpO
1 = Video/source detected, without HDCP
1 = Sink detected, output not HDCP encrypted
X!
HdcpE ]
X!
]
X!
]
HdcpE
DTP3 T 202 / DTP3 R 201 • SIS Configuration and Control
Additional Description
Input*Outputs 1‑2
Input*Output
19